Skull Cap Spinner Assembly (small) for Cessna, FAA/PMA approved. For wood or metal propellers on Cessna C-120, C-140, and C-140a Note: The spinner dome and the spinner bracket are included with assembly. |
![]() |
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov |
For a more more aesthetic part it would be nice if it had less scratch marks in the aluminium.
Mount bracket is so thin that it twisted and deformed when the prop bolts were torqued to specification. Terrible engineering done on this mount bracket, and its FAA/PMA. Really?? Found a used older bracket that was twice as thick to use. Stamped UNIVAIR all over it. Dont waste your time or money. Spinner is fine, no problems there.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, they can be.
Dome diameter: 5.125 inches outside diameter
No this kit is made up of spinner dome (U0450279) and bracket (U0450281).
There is no paperwork included in the box, however, they are stamped as FAA PMA.