FREE SHIPPING ON ORDERS OVER $350 (USA ONLY - SOME EXCLUSIONS APPLY) | 877-4-SPRUCE
Thumbs 1
Thumbs 1

BRACKET & HARDWARE FOR SKULL CAP SPINNER

$13.75/Each
Part# 05-21800
MFR Model# 10203

Overview

Bracket and hardware ONLY. Fits any skull cap spinner.

Reviews

The bolt holes are 7/16 diameter without enough edge clearance to drill up to 1/2 so I could not use it on my Lycoming O-360 which uses 1/2 diameter bolts.

Jeff T
September 6, 2018

There needs to be more edge distance where the holes are drilled and I used a bit of JB Weld on the screw to prevent it from loosening.

Bill
February 20, 2020

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What size screw does part# 05-21800 use?

It is a #10 sheet metal screw. Our part number is THB10X12.

Q: What is the center to center distance between the 2 mounting holes? Is this bracket for the 6 inch skull cap?

Center hole to center hole is approx. 4-5/8". This is used with the 5" and 6" skull spinner caps.

View in Catalog

View Image View in Catalog