CSR is made from durable Torlon® material that can remove sealant in many applications at a lower product cost with greater efficiency and productivity. For aerospace applications, CSR is safe to use on common protective coatings and structural materials.
CSR series can be used with 1/4”-28 UNF, 1/4” collet, and drill chuck interfaces. Screw in or attach/lock into rotary tool.
CSR cuts by rotating in the clockwise direction. Operate the CSR at 200-400 RPM for better controllability while avoiding heat buildup. Heat will accelerate wear on the CSR and may generate undesirable odor from the sealant. For general applications, use the CSR-10 to engage an edge of the sealant and allow the rotating action to cut through at the bond line.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Does a great job. Be patient with the tough spots, too much rpm will result in getting the tool too hot and ruin the tool. Still a good product but if you have a younger crew buy a few extras for the learning curve.
CSR-10 COMPOSITE SEALANT REMOVER
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.