Fuel Compatibility: All models of the Facet Posi-Flo Pumps are compatible with gasoline, diesel, biodiesel, blended alcohol fuels and fuel additives.
Reliability: Proven on thousands of original equipment applications. No bearings, electrical contacts, or diaphragms to wear out or fatigue. Lasts four to five times longer than many other
Easy to Install-Easy to Service:Two bolt installation plus the small size makes installation easy. For best results, mount the pump close to the fluid or fuel tank and below the liquid level.
Eliminates Vapor Lock: When properly installed on most vehicles a constant, smooth, dependable supply of fuel under pressure is assured in the hottest weather or in high altitudes.
|PN||OEM PN||Description||Volts||PSI Max- |
|Lift Min. |
|Position Shut Off |
|05-10856||60106||Facet Psi-Flo Fuel Pump||12||7.0-4.0||32||1/8 - 27 INT||12"||N||N|
|05-10880||60245||Pump Kit- (2ea.) Straight Fuel Fittings||12||4.0-1.5||23||1/8 - 27 INT||12"||N||N|
|05-06862||60300||Facet Posi-Flo Fuel Pump||12||4.0-2.5||20||1/8 - 27 INT||50"||Y||N|
|05-06863||60301||Facet Posi-Flo Fuel Pump||12||5.0-3.5||30||1/8 - 27 INT||50"||Y||N|
|05-06864||60302||Facet Posi- Flo Fuel Pump||12||7.0-5.0||32||1/8 - 27 INT||50"||Y||N|
|05-10881||60303||Facet Posi-Flo Fuel Pump||12||10.0-7.0||34||1/8 - 27 INT||50"||Y||N|
|05-10882||60304||Facet Posi-Flo Fuel Pump||12||2.0-1.0||15||1/8 - 27 INT||24"||Y||N|
|05-01250||FEP04SV||Pump Kit- Straight Fuel Fittings, Nuts, Screws, Fuel Filter||12||4.0-1.5||23||1/8 - 27 INT||12"||N||N|
we use these fuel pumps for gas marine engines, they have the proper lift for the in hull fuel tanks.
Nice quiet little pump. Works well.
Just had a new one of these, number 60304, go bad after three hours. Initial installation was good and the pump was a solid unit - passed all tests. Installed with good pre-filter, at tank-bottom level so no lift issues, fresh gas running a 70:1 Blue Max mix on fresh 93 octane 10& ethanol. Not sure exactly when the pump quit. It still sounds like it is running, with the characteristic clicking sound, but fuel is barely creeping up the fuel line and output might be a few tablespoons per hour. Discovered on a motor swap and final flow/pressure test of the fuel system. Will install a fuel pressure gauge to monitor the replacement.
Replaced older mechanical fuel pump with 60300 on my 1970 Citroen and it works well. Thanks
Quality but inexpensive unit. Made in USA and easy to install. Shipping was quick!
Part is high quality and was delivered timely.
this is a great pump for my lawn tractor but AS should have adapter fittings on the same page. 5/16 fittings are no good for lawn equipment.
been using this pump for several years as my backup pump. Im going to get a new one now just to make sure I dont have to change it out there. it sure has saved me a couple times now.
Used this pump in my garden tractor when the vacuum pump failed. Worked just fine. Have had no problems with it.
Per the tech data this unit has a check valve, but does not have a positive shut off, so it will flow in the normal flow direction when off.
Regarding Part # 05-06862 (FACET 60300 POSI-FLO PUMP), the distance center to center of the mounting holes is approximately 2-1/2".
This pump weighs approximately 0.79 lbs.
The tech data sheet does not mention these kerosene or Jet A specifically. It does mention that this unit can be used with gasoline, diesel, biodiesel, blended alcohol fuels, & fuel additives.
INT would represent internal (female) NPT thread. So yes, this will work. You can choose any kind of style fitting you like at the other end.
This is only the fuel pump.