|JPI option EDM carb temperature probe, 1/4-24 thread 400128.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Sensor was easy to install and no issues with the quality. I did have to do some digging on what the torque specifications were for the fitting into the carburetor that should of been included in the instruction sheet, thus the 4 star rating. There is a problem with the item description. The thread size is posted as a 1/4 - 24 and in reality it is a 1/4 - 28. The carburetor on my 182 is a Marvin - Schebler MA-4-5 and I confirmed this thread size with them. I also contacted JPI and the technician looked at his specifications and said that the sheet showed a 1/4 -24, but it had been scratched out with 1/4 - 28. I think it would be worth you time to contact JPI and get this straightened out. Who knows, you may be losing sales because of this error.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, it is 1/4-24 thread and will work on the Marvel Schebler carbs you mentioned.
Per JPI, the EDM-700 will automatically recognize the probe when it is installed.
Yes, this will work with the EDM 830.
Please order 10-07081 for the EDM 350 option.