These switches are used with the Westach CHT, EGT, or CHT/EGT gauges to allow multiple cylinder engine analyzing. Switches included with Engine Analyzer kits & Add-On kits on following pages, or can order separately below. Non-TSO’d. These switches have two small connectors of same size.
Made in USA
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
I had to return the first one of these I purchased as it was defective. The switch only had 4 positions even though it had the right number of leads for 6 sensors. The replacement worked correctly.
WESTACH 6 POSITION SWITCH W/ 8 LEAD 254-6F NON TSO
Just as ordered
WESTACH 4 POSITION SWITCH W/ 8 LEAD 254-4F NON TSO
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
This has a push on pin/socket style connectors.