Non-TSO’d fuel quantity indicators available for single or dual tanks. Requires 0-5V capacitance senders (not incl.)
Note: Westberg 712 Series Thermocouples are for Non-TSO’d CHT & EGT Gauges only. They have two small pins which are the same size.
Made in USA
Works great! I initially bought the more expensive temperature compensated gauge which did not work at all. Apparently it was defective out of the box. I replaced it with this and finally have a gauge that works. Very pleased with it.
Easy to instal and worked great!
WORKS as advertised good value
Good product, works great with my Westach indicator BUT I delayed purchasing it because the â€ś4 wireâ€ť in the description confused me. The old one is a 2 wire. I dug deeper and figured out they meant â€ś4 foot wireâ€ť. I went to the Westach website, figured out which probe I needed then went back to AS with the correct part number. AS could have saved me the trouble.
Received ahead of schedule and it works great.
This switch works well, and the cable is just the right length for a Long EZ. However, the switch is relatively inexpensive, and only seems to last about 3 years before needing replacement.
The casting of the case is unacceptable in any case (tso or not) The back plate still has spurs from the molding process. The back plate bows in the middle between all four corners. I have not installed or run this gauge, but not expecting much. This gauge would be OK at $30-40.
They are both are EGT probes, but p/n 10-01225 is non-tso approved while p/n 10-01228 is FAA TSO approved.
Yes. Our part # 10-01226 is ordered directly from Westach under 712-5WK. They are the same product.
Part # 10-01230 is priced and sold individually, one probe.
No, part # 10-01226 is non FAA TSO approved.