|Thickness||Wt./Sq. Ft. (Lbs.)||Part No.|
HIGH PRESSURE LAMINATED PHENOLIC
Commonly called “Micarta”, a trademark of Westinghouse. Laminated sheets, tube and rods are produced in many grades, sizes and colors. These laminates combine a base material- canvas, linen, paper, glass cloth or Nylon cloth, with a resin-phenolic, melamine, epoxy or silicone, under high heat and pressure to produce a new material with specific characteristics. These characteristics vary with the grade and its use.
GRADE L (Linen Base)
Used for precision machining and high strength applications.
Sheet Size: 36" x 48".
Sold in 6" x 6", 6" x 12", 12" x 12", etc. pieces only.
Less 15% for full sheets
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
PHENOLIC SHEET 3/4
what i ordered
High quality item delivered on time as promised.
Just what is says. I ordered 6 X 6 piece and it was cut nicely so no waste from the cut line.
I purchased 3/16 phenolic sheet to make small scrapers for paint removal. I cut 6 lengths to various widths ground an edge on one end and rounded the other end so it wouldnt hurt my hands and presto! - a nice tool for scraping off paint or sealant without hurting aluminum. I gave this latest batch 4* rather than 5* because Im not sure it holds an edge as well as some previously purchased phenolic it seemed to fray a little quicker. But, I would buy it again if I run out of my current stock.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
This material is sold by the square foot. Per the dimensions listed above, customer will need to order 1 sq ft, so 1 is the quantity to input, then click required information in the shopping cart and advise to ship as 2 pieces at the desired size. If customer only wanted one piece 6"x12", the quantity to order is .50.
The MIL Spec for this item number is MIL-I 24768/13.
Some sheets are a little darker than others, but for the most part they are all yellow / amber as shown.
Yes. Phenolic sheet has a flat smooth surface. Follow the prep instructions on the primer and paint being used.
Some sanding is recommended to get a good mechanical bond when laminating.
It is priced and sold by the foot. Quantity 1 receives 1 foot.