HIGH PRESSURE LAMINATED PHENOLIC
Commonly called “Micarta”, a trademark of Westinghouse. Laminated sheets, tube and rods are produced in many grades, sizes and colors. These laminates combine a base material- canvas, linen, paper, glass cloth or Nylon cloth, with a resin-phenolic, melamine, epoxy or silicone, under high heat and pressure to produce a new material with specific characteristics. These characteristics vary with the grade and its use.
GRADE L (Linen Base)
Used for precision machining and high strength applications.
Sheet Size: 36" x 48".
Sold in 6" x 6", 6" x 12", 12" x 12", etc. pieces only.
Less 15% for full sheets
what i ordered
High quality item delivered on time as promised.
Just what is says. I ordered 6 X 6 piece and it was cut nicely so no waste from the cut line.
I purchased 3/16 phenolic sheet to make small scrapers for paint removal. I cut 6 lengths to various widths ground an edge on one end and rounded the other end so it wouldnt hurt my hands and presto! - a nice tool for scraping off paint or sealant without hurting aluminum. I gave this latest batch 4* rather than 5* because Im not sure it holds an edge as well as some previously purchased phenolic it seemed to fray a little quicker. But, I would buy it again if I run out of my current stock.
This material is sold by the square foot. Per the dimensions listed above, customer will need to order 1 sq ft, so 1 is the quantity to input, then click required information in the shopping cart and advise to ship as 2 pieces at the desired size. If customer only wanted one piece 6"x12", the quantity to order is .50.
The MIL Spec for this item number is MIL-I 24768/13.
Some sheets are a little darker than others, but for the most part they are all yellow / amber as shown.
Yes. Phenolic sheet has a flat smooth surface. Follow the prep instructions on the primer and paint being used.
Some sanding is recommended to get a good mechanical bond when laminating.
It is priced and sold by the foot. Quantity 1 receives 1 foot.