Decalin RunUp is approved for use with the new 100VLL (Very Low Lead) fuel announced by the FAA on Special Airworthiness Bulletin NE-11-55. Decalin RunUp contains two types of additive, one to reduce the negative effects of tetraethyl lead in aviation fuel and the other to improve the combustion efficiency, reduce combustion deposits and clean the fuel delivery system in aircraft. Users can expect the same level of engine cleanliness when using this fuel and Decalin RunUp as they saw with 100LL.
Make sure you remove and clean your oxygen sensor every 20 hours to remove these lead phosphate deposits when using Decalin RunUp. The dosage of 1/2 ounce per ten gallons of fuel is a minimum. This can be increased to a maximum of 2 ounces per ten gallons for problem engines. Decalin RunUp is not approved for use in the engines of certified aircraft but it has the same active ingredient, Tri Cresyl Phosphate as our previous product. Lycoming clone users have reported very good results when using this product. RunUp MSDS Notes: Some white deposits may be seen on the plugs and in the exhaust pipe during use; this is normal with RunUp since the lead in the fuel is being converted to non conductive lead phosphate. When no additive is used, lead oxide is formed. It is lead oxide which causes plugs to misfire due to its partial conductivity shorting out the plug. In addition, lead oxide tends to form in large clumps or clinkers whereas the lead phosphate is crumbly and if anyy is left behind in the combustion chamber it deposits in even layers. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Decalin Fuel Additive 16 Oz
On time and as advertised.
Decalin Fuel Additive 16 Oz
Does what it’s supposed to.
Decalin Fuel Additive 16 Oz
Ingenius, easy to use dispenser!
Decalin Fuel Additive 16 Oz
Decalin Fuel Additive 16 Oz
helps keep plugs clean, and can be safely transported without HAZMAT, easy measurement dispenser
Decalin Fuel Additive 16 Oz
OK
Decalin Fuel Additive 16 Oz
AAA+++ EXCELENT!!
Decalin Fuel Additive 16 Oz
I use this in my experimental aircraft. It does what it is supposed to do.
Decalin Fuel Additive 16 Oz
I use Decalin in my IO-320 and O-290 to help scavenge lead deposits, It really keeps the spark plugs clinker-free and eliminates pre-ignition and detonation. It especially makes a huge difference in smoothing out low rpm idle.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
This product has a two year shelf life so yours may not be good anymore. This product is table down to -60 degrees C. This will not freeze or separate at any temperature. Please see the tech data sheet in the 'Documents' tab for more information.
The short answer is yes. This has an advanced deposit removal ingredient which will remove existing deposits. Depending on the quantity of the deposit, this may take time to achieve, but generally one or two full tanks of fuel will do the job. Fuel injectors and throttle bodies get cleaned up as well at the same time.
Yes, Decalin Runup is compatible with auto gas. Decalin should be added in proportion to the 100LL being added. There are no negative effects to doing this.
Per Vendor, Yes the Declain Runup is compatible with fuel resistant composite fuel tanks along with fuel resistant fiberglass cloth and epoxy resins and hardeners.
10 quarts per case.
Per the Supplier: All our experience so far says that this issue is unrelated to the addition of Decalin RunUp to 100LL. The ingredients in this product are miscible in all proportions with aviation gasoline. To speculate, cold weather causes condensation in fuel tanks, so this issue may be more related to the season.
The active ingredient in Decalin RunUp follows the “lead” of the lead, if you’ll excuse the pun. It reacts with a majority of the lead in the fuel to produce lead phosphate which is mostly blown out of the exhaust. Remaining lead in unburnt fuel finds its way into the oil by bypassing the pistons. The ingredient is already dissolved in the fuel and goes with it into the oil sump. There it acts as a suspending and dispersing agent, preventing the lead from precipitating and agglomerating into an abrasive sludge. It also performs other useful duties by helping to remove carbonaceous deposits in the oil galleries.
Shelf life is 2 years from the date it is shipped to us. This is unopened, and storage would not add to shelf life.
Yes, Decalin RunUp will work just as well with fully synthetic oil in suspending the lead in the oil. There is a limit as to how much lead it will hold in solution and here is some reported data in a Rotax engine using synthetic oil. The results indicate that after 91 hours of operation my oil contained 1098 ppm of Lead (Pb). During the 91 hours of operation I used 49.85 gallons of 100 LL fuel, all of which was treated with Decalin at the rate suggested on the product.
Yes, there is a date code on the bottle.