FREE SHIPPING ON ORDERS OVER $350 (USA ONLY - SOME EXCLUSIONS APPLY) | 877-4-SPRUCE

A-950 CONTROL 36"

$73.75/Each
Part# 05-16936
MFR Model# A-950-0360

Overview

(10-32 Threads / Solid Wire End) Same as A-920 control except one end is .078" dia. stainless steel wire. Special-length controls not required as the wire end can be cut off to desired length.

Made in USA
  • Customers Also Viewed
  • Frequently Purchased With

Reviews

Decent! Using this to convert RV6-A to electric trim. Paired with an roy allen trim servo this should work great! Also, the hole in the servo arm is a bit oversize for this cable, so I used a pop rivet without the mandrel as a makeshift bushing and it takes up all the extra play. Perfect fit with zero play in the linkage.

Anon
December 28, 2020

these cables are very good quality product

Ronnie D
August 31, 2019

This cable requires 10464 or 10465 cable mounts. No mounting brackets are included with cable.

Don
May 9, 2017

Very good product as expected. What I was missing was cable diameter in catalogue, to be able to order the right gromets at the same time.

Jerry
February 17, 2020

I recently purchased two of these cables. One worked get. The second one had very rough and grinding action. I had t o tear it apart, where the wire was swaged to the end it was a very poor job. I was able to effect a repair ,but was kind of dissatisfied with the QC of the part.

Bob B
March 2, 2020

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Do the A-950 push pull controls come with a standard right hand thread?

Yes, these cables have a standard right hand thread.

Q: How do you terminate the bare end to attach to the carb throttle arm?

If the thottle arm has a 3/16" hole, a bolt type terminal could be used, our part number 05-16100, but the installer would need to review and verify this is the best product for that specific application.

View in Catalog

View Image View in Catalog