|Piper J-3||Piper Shock Boots||PAIR||09-17360|
|To keep your aircraft components clean from contamination by dust, grime and dirt, install these quality covers made from black vinyl. No mounting hardware included.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Installed on a Cessna 172. Fit great no issues at all.
Stitching was off on part of the velcro tab. Will need to re-sew It before installation. Otherwise seems like a good quality part
I purchased the Beechcraft gear boots and could not get the snaps to close. Poor quality control seems to have done them in on this one. The actual boot itself was good quality and fit perfectly. To bad the snaps didnt work.
quality was cheap... not for me... sorry! returning
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
All of these boots have unique measurements. If your aircraft is not listed, we can do special order boots. The two options would be to send us your original boots to copy or give us a detailed pattern with exact dimensions. These would be non-cancellable and non-returnable. To set up the order, please contact sales at 977-477-7823 or email using the "Contact Us" link in the upper right portion of every web page on our site.
No these are not FAA approved.
The height is approximately 6" from bottom of sewn seam to the top of the hole when laid flat. The diameter of the bottom circle when opened is approximately 6-1/4".