Nylo-Seal tube fittings are exceptionally strong. The bodies, made of nylon, are stronger than machined fittings of similar composition. They are furnished complete with nut/sleeve assemblies, made of acetal copolymer. Since the sleeve snaps into and is retained by the nut there is no fumbling for a loose sleeve. Just insert tube into the fitting and tighten the nut 2 to 2-1/2 full turns. Note: The most frequently used combination of tube and pipe sizes are 1/4" Tube x 1/8" Pipe and 3/8" Tube x1/4" Pipe.
For Nylo-Seal tubing, see "Accessories" tab Less 10% on 50 pieces per size, Less 20% on 100 pieces per size |
259-N Insert (Nylon) | Sleeve Assembly | |||||||||||||||||||||||
![]() |
| ![]() |
|
| |||||||||||||||||||
![]() |
|
264-N Union Tee | ||||||||||||||||
![]() |
|
| ||||||||||||||||||||||||||||||||||||
![]() |
|
| ||||||||||||||||
![]() |
|
268-N Male Connector | ||||||||||||||||||||||||||||||||||||
![]() |
|
| ||||||||||||||||||||||||||||||||||||
![]() |
|
| ||||||||||||||||||||||||||||||||||||
![]() |
|
| ||||||||||||||||||||||||||||||||||||
![]() |
|
| ||||||||||||||||||||||||||||
![]() |
|
*Use 259N inserts w/all Poly-Flo tubing connections. Not needed w/ Nylo-Seal tubing. | |
These are back ordered, have not received a new shipping status.
I made a mistake with the last rating, in fact Aircraft aircraft spruce has shipped the missing item so please accept my apology. Thank you for prompt shipping. Rich
I got what I ordered, good job!
took a little time to locate the insert, but was a correct fit. Staff very helpful
The first number in the size column refers to the tube OD, second number is the pipe thread. In your example, 1/4 tube OD x 3/8 pipe thread.
You would install a cap in a fitting where you would want to cap off the flow. Place the cap in the fitting and tighten the nut down.