• Wishlists
  • 877-477-7823
  • Contact Us
 
 
FREE SHIPPING ON ORDERS OVER $350 VIA UPS GROUND | 877-4-SPRUCE

PSA ENTERPRISES LED REPLACEMENT LAMPS FOR NAV LIGHTS

Select Lamp:
RedGreenTail Position
Select Voltage:
1224
Quantity
Add to Wishlist

Overview

Upgrade your Indicating, Position, or Recognition lights to LED's.

These lamps fit standard S.C. Bayonet Indexed Base Sockets (Bay15S). Converts common Incandescent Lamps to LED Lighting without modifications.

It's simple! Just replace your old incandescent bulbs with the new LED Lamps where acceptable. (Use a new clear plastic lens for maximum brightness) and you are ready to go.

Our 15mm (Bay15S) Lamps are available in 12 & 24vdc, Red, Green, and non-indexed Clear. They last longer, run cooler, and draw less than .15amps.

Not PMA'd.

Note: This bulb is a standard 75/12 replacement for any Grimes, Whelen, AeroFlash Wing Tip Light Assembly.



  • Customers Also Viewed
  • Frequently Purchased With
  • Accessories

Reviews

I only give the clear tail bulb a one star, I have purchased 6 of these bulbs and not a one of them would go into my Cessna 172s with out filing a portion of the bayonet pins. The last one the pin broke off, so now I have a $33.00 paper weight, (only with no wind). I have sent in one of the red ones for warranty, a number of the individual LEDs in the have failed. During a 100 hour inspection this past week we found another red one with burned out leds. I am going to try another manufacture.

L &
September 8, 2019

1.3hrs, still shining!

Alan
August 27, 2019

Great while it worked. Failed prematurely after only a few hundred flight hours (very few of those hours powered on.)

Chris
June 10, 2019

I bought these to replace another brand of LED lights that were causing problems with my radio. They are very bright and do not cause any static over my radio. I bought both wingtip lights and the white tail light. So far they are great. i run them all the time.

Joe F
February 26, 2019

Everything was easy to replace, cover and bulbs. We ordered the red lens to replace a missing lens cover, but the main reason for the red and green led bulbs was this: We display a non-flying 1968 UH-1H Huey to the public which is on a trailer. Our problem was that kids would put their hands on the operating lower incandescent bulb position lights which, even on flash, get quite hot. The leds remain cool and their little hands are safe. The reachable upper ones are still incandescent and we are saving our donated nickles to replace them.

Bill J
January 21, 2019

No complaints from me. Installation was fast and easy, and the bulb works as advertised. There simply is no comparison in brightness between this and the old incandescent bulb. Hint - for even greater brightness, get the clear lens. Makes a world of difference.

Rick
January 2, 2019

Hello All, I have these installed on my J3C-85-8 , with a Basic BT-14 wind driven alternator with an EarthX battery installed for radio. in Grimes Model B wing tip light mounts.. And they fit, ln the old style reflector ) and put out a very crisp highly visible light that is brighter than an incandescent #93 But when turned off, with the R&G colored dome lenses, the LED are not readily seen so if someone is looking at them, there is no telling that they are not old type bulbs. Great product, and reasonably priced too.

Tigger
November 17, 2018

Nice and nirigyt fit like to originals!

Sean K
November 5, 2018

The lamps are great, but use caution when ordering a clear one for your tail lamp. I have Whelen lights all around. The wing tip position lamps fit and work well in the Whelen sockets. Beware that you MUST order the clear lens to replace your red/blue ones. However, my Whelen tail lamp had a combined position and strobe bulb combo, so the clear LED bulb did not fit.

Gmn
October 12, 2018

Brighter and more vibrant than the stock bulbs in both day and night conditions. Easy install, lowering my amp draw

James T
September 8, 2018

Q&A

Q: Will this bulb fit for a Grimes 1512 bulb?

The LED base has the same dimensions as the 1512 bulb. It should work just fine.

Q: Any problems with it passing annual since it says non-PMA?

This product will not cause a problem passing annual.

Q: As this LED nav light is non-PMA'd do I need an STC?

This product is not certified (TSO'd) or PMA'd and so you cannot get an STC for it. If installing on a certified aircraft you will have to obtain a FAA field approval (337 form) as this part is intended for experimental aircraft only.

Q: Will the tail lamp 11-07748 (LED75TPL-12V) replace GE1156? What is the Lumen output of 11-07748 (LED75TPL-12V)? What is the Lumen output of the 11-07744 and 11-07745 (LED7512-12V)?

Yes, 11-07748 will replace GE1156. Regarding the Lumen output, the FAA requires light output be measured (in foot candles). The tail lights (11-07748) require only 20 foot candles output. The wing tip Red & Green require 40 foot candles min. @ 0 degrees. To convert foot candles to Lumens: Lumens per square foot = foot candles multiply by (1). It is a (one to one) to foot candles which says that 20FC = 20 lumens per SQ foot (Taillight). 40FC = 40 lumens per Sq. Ft., (Red & Green wing tips).

Q: I think the prev answer is not quite right. A lumen(lm) is a measure of light flux. If that 1 lumen of flux is concentrated in a cone of 1 steradian, the intensity will be 1 candle power (now renamed candela). There are 4pi steradians in a sphere, so the conversion is 12.5 lumen = 1 candlepower. LEDs are spec'ed in lumens but aviation product should be spec'ed in the more meaningful candela or candlepower as in the regs.

This was the answer we received from the manufacturer. As a distributor only of this product, we cannot say for sure one way or the other as we do not have technical proficiency in these lights.

Q: Will this bulb fit for a GE-1141 bulb?

Per the supplier: No, it will not fit in the same socket.

Q: What is the current draw in amperes of these bulbs at 12v nominal?

Per the supplier: it is less than 0.2 amps.

Q: Is this the complete lamp like I see in the pictures, or only bulb?

This bulb is a standard 75/12 replacement for any Grimes, Whelen, AeroFlash Wing Tip Light Assembly.

Q: Will these replace Whelen PN: W1290-14 lamps?

Per the manufacturer, The LED replacement lamp will fit and work as a replacement for the Whelen lamp. Please keep in mind that for the FAA, it is currently not an approved PMA'd lamp.

Q: Will this fit the Whelen A555A series strobe/tail position light that uses a pn#11-03216 halogen replacemnet bulb?

The PSA Enterprises LED replacement Lamp has not been tested to fit inside the Whelen A555A series light by either manufactuerer and is not recomended as the PSA lamp is not PMA'd and the A555A is FAA TSO'd.

View in Catalog

View Image View in Catalog