Quickly Flushes Out Old Grease and Repacks Bearings with Less Mess.
The Handy Packer works on bearings up to 3 1/2" O.D. The grease stays in the tool cavity, not on your hands. To pack a bearing, place the bearing on the piston. Press down on the cap until the old grease is forced out and the new grease shows on top of the bearing.
Download the Instruction Sheet
good tool to have
LISLE HANDY BEARING PACKER
I dont understand why someone wouldnt clean out old grease and inspect the bearings before inserting new grease. If you take the time to do this, the packer works great.
This little jewel is slicker ‘n snot on a doorknob if you DIY your own wheel bearings,
If you clean your old bearing first then you can easily use it by hand
Worked exactly as advertised and repacked our bearings efficiently without the mess (or at least less of the normal mess)
nice looking, easy to lad up with grease, easy to lube bearings
Works perfectly. I read many of the negative reviews before purchase. Many people were saying how hard it is to press down. Not sure what kind of grease their using to pack a bearing but I used AEROSHELL 5 grease to pack my bearing and could easily press it down with one finger. A little baby could press the thing down!
Ive been using this bearing packer for years. Much easier work flow and I stay cleaner to get the job done than doing it by hand. Many complain here that it is difficult to push this bearing packer together in order to push the grease through the bearing. Well, just step on it. Just step on it and turn your foot, while standing on it, 20 degree left then right 3 or 4 times, done. I position the bearing into the slot, as dirty as it comes out of the plane, put the bearing packer together, place a plastic bag over the whole thing (I use the same plastic bag for years, so Greta doesnt have a reason to cry) put the whole thing on the floor and step on it with my whole weight (200 lbs or so), do my left and right dance and 8.5 seconds later the work is done. The old grease is pressed out and replaced with new one. The old grease then can be removed with something like a stirring stick.
I have been using one for years. At first I was disappointed with the amount of effort it took to press grease into the bearings but I have found the bearing packer to be a faster and cleaner option than packing the bearings by hand and will use one if it is available. Be cautious when using a press on the packer. A buddy managed to break his so the grease zerk cannot be used to refill the packer.
Use a drill press or arbor press for leverage to force the grease and they work great
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.