Unidirectional Spar Cap Fiberglass Tape

Add to Wishlist
Part# 01-01651
MFR Model# UNI850075


This 54 Yard roll of woven unidirectional tape consists of a plain weave construction with at least 80% of the fabric weight in the 0 or Warp direction.

This unidirectional tape can be used instead of unidirectional fabric for spar caps, wings and elevators. Contours well and cuts building time considerably. May be used with either polyester or epoxy systems. Used on Polliwagen. Long-EZ, Cozy. Adventure and applicable to all composites.

Fiber: E-Glass Fiberglass
Product Type: Woven Tape
Construction: Unidirectional
Density: 850 g/m2
Width: 3" (75 mm)
Length: 54 Yards
Finish: Silane
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.



Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Do you know if this will work with vinyl ester? What is the stitching material and the exact sizing on the fiberglass?

Yes it should work fine with vinyl ester, it is standard e-glass. The sizing is below. BRBR Density: 850 g/m2 | Width: 3 (75 mm) | Length: 54 Yards

Q: What is the thickness?

The nominal thickness of this tape should be 0.7mm or 0.0275 inch.

View in Catalog

View Image View in Catalog