Swift Gauge Dual 2-1/4" Oil Pressure / Oil Temperature Gauge.
Not FAA ApprovedSimilar to Falcon Gauge
Made in China
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Very pleased with this gauge, simple, light and robust (and custumizable friendly).
Poor quality. Inaccurate readings on gauge if it works at all.
SWIFT 2-1/4" DUAL OIL TEMP 100-260F 80PSI
Total Rubbish. Oil Pressure reading suddenly drops to zero and wont read properly again until powered off and on again for some reason. Oil temp just as unreliable, although sometimes it just doesnt read at all. Oil pressure is critical to safe flying. Although a good idea, I would not trust this gauge at all.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The Falcon Gauge 2-1/4 Dual Oil Pressure / Oil Temperature Gauge 120-300 F / 80 Psi is an electric gauge.
The Falcon Gauge 2 1/4 Dual Pressure / Temp Gauge does not include the 14mm probe with 4-ft. leads. See "Accessories" tab for correct sending units. Gauge leads may be extended with 18-gauge wire.
Per the manufacturer it is 48.2 mm or 1.90 inches.
The wiring diagram is included as a hard copy with the unit. Yes, the wiring diagram shows 8-30vdc.
See part number 10-06345, for Rotax 912/914 engines.
No, this gauge is not lit.
The install instructions shows an 1/8 NPT probe is needed. Part # 10-04057 matches the installation guide 100psi.