We offer a revolutionary new molded seal for Beech aircraft doors and windows using a special hybrid rubber compound. The new seals provide air tight as well as water tight doors and windows. In addition they also greatly reduce the cabin noise level making flying even more enjoyable.
These seals have been under development, testing, and FAA approval, are molded (in tooling specifically designed for aircraft) to fit on the door of your plane and are superior to any seal on the market. The new seals come in complete kits and are available at a fraction of the cost of OEM seals.
These seals are FAA-PMA certified for Beech, Cessna, Mooney and Piper (un-pressurized with reciprocating engines) aircraft.
*For specific model #'s see Application Guide*
** Late models have a channel for the seal to fit
***P/N 05-03494 "Aft Utility Door Seal Kit" is applicable to Models A36 and B58
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
|Front entry |
door seal kit*
|Baggage Door |
Seals (Fwd & Aft)
|Storm Window |
|Emergency Exit Window Seal (Early)|
|Emergency Exit Window Seal (Late)**|
|Nose Baggage door Seal (Twins)|
|Aft Utility Door Seal Kit (A36 & B58)|
Installed as per instructions. Let seal warm tô temp over night. Installed in my Bonanza in a warm heated hanger. Door kept opening inflight. Had to remove and install another type of seal. Worst $200.00 I have spent. Dont waste your money or time. Very bad product. However the hinge seals are very nice and recommend the hinge seals
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Just make sure where you attach the seal and where you apply the sealant is clean. There is no special cleaner that must be used. You can use Part # 09-01361 for your adhesive.
You could use 09-01361 for adhesive. We do not have a recommended cleaner to remove the old glue but a generic residue remover should work.