Ranthane Aircraft Coatings
Ranthane requires three separate components (which are sold separately, see Options tab) that are mixed before application. All three components are required and cannot be substituted: Ranthane polyurethane paint, AU-2X1 Catalyst, and G-4200 Ranthane Thinner.
Mixing: Mix two parts Ranthane with one part AU-2X1 and stir. Allow to sit for 20 minutes induction time before use.
Thinning: For best results, thin 33%, then spray a vertical surface test area with a moderate coat to insure that the film has no orange peel and is not too runny.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Got it. Back order came through in minimum time - thanks, Lee
As usual, Ranthane is am Excellent product
Excellent Paint, I have been using Randolph Ranthane since 1975. Mandatory to use proper safety equipment when spraying.
One of the best aircraft paints ever.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, the catalyst must be used, and is sold separately.
Yes, you can use part number 09-02052 (pint) or 09-02051 (quart) for Ranthane paints.
We can mix the Ranthane to the formula given, but it is a special order item. Be sure the color is correct for your application, and we will mix to their formula. To begin the special order process, please call sales at 877-477-7823.
Ranthane is not short filled. Depending on the pigments needed for a specific color, the tinted base color is approximately one gallon.
Yes, it will work on both fabric and primed metal surfaces.
Ranthane may be applied directly over fabric surfaces when the Rand-0-Fill silver butyrate has dried at least 36 hours. More drying time is better. Epoxy primer should dry for one week over metal or composite surfaces before applying Ranthane. If you are painting a light color you would use the white epoxy primer.
They recommend EP420 epoxy primer.
Try a keyword search for EP-420.
This is a 2:1 mix, so two parts Ranthane to one part catalyst.
We mix the paint in-house.