Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
1-HOLE
3-HOLE
FREE Shipping
Overview
|
Prevents inadvertent operation of the switch. Switch can be operated only when the spring-loaded guard is lifted up. Returning guard to the down position forces the switch lever to the off position. Single-hole type for neck-mount switches such as AN3021 and AN3027. Three-hole type for panel-mounted switches such as AN3023. Color: Red. |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Specifications
- 1-Hole Switchguard: 5/8" W x 1-5/8" L. 1/2" Hole
Reviews
Aviation quality switch guard, installed this on my avionics master after a passenger turned it off accidentally on decent into the Dallas area. Good stuff, okay price.
Verified Purchase
Switchguard MS25224-1 (1-Hole)
EXCELLENT! Exact Mil spec match to what is already in my aircraft. Positive powerful closing snap. Disregard the other reviews on here that say the size isnt right for a Mil spec toggle switch, It is. It works perfectly, and closes fully. A mil spec toggle should be set to the proper height using the screws to adjust during install. I have these in my aircraft and they are exactly right. No dremel needed. Just set the proper switch height.
Prompt And Timely shipping
Verified Purchase
Switchguard MS25224-2 (3-Hole)
Verified Purchase
Switchguard MS25224-1 (1-Hole)
Excellent value. The fit and finish are super. The satisfying snap when you close it is more addictive than clicking a pen, and louder, enough to make the dog jump if you sneak up on him. My only complaint is that I have to hold it with one hand on final at night or it might snap down and turn off my landing lights.
Verified Purchase
Switchguard MS25224-2 (3-Hole)
Bad design. Does not cover threaded neck of toggle switch. Dremeled and dremeled but it still looks half-open. Disappointing.
Verified Purchase
Switchguard MS25224-1 (1-Hole)
These are supposed to match with the AN3021, not so much. The guard is too narrow for the toggle so in does not really fit over the handle when closed. Looks very unprofessional.
Q&A
Please note, Aircraft Spruce ®'s personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce ® assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, this switch guard is intended to prevent inadvertent operation of the switch.
