Swift 14MM CHT Sender

Add to Wishlist
Part# 10-02287
MFR Model# SJ-R14


14mm dia. ring, 4ft metal shield wire.

Similar to Falcon Gauge
Made in China
  • Customers Also Viewed
  • Frequently Purchased With
  • Related Items


Michael G Verified Purchase


December 8, 2021

This is a replacement - the terminal of my previous sender broke off. Very easy to do if the installation requires a tight bend. Otherwise does the job well

Andrew P Verified Purchase


August 20, 2021

Works great easy installation I will order from them again thanks

Bob W
June 25, 2019

I bought these along with the Swift dual CHT gauge for a boxer engine motorcycle(not a BMW). Piece of cake to install and works well.

Michael B
July 12, 2017

Purchased for the recent addition of a CHT indicator installation on a Continental O-200A. Worked perfectly and are of high quality. I strongly recommend this product

Yancey H
May 28, 2017

Built with a thin spark plug washer so response is fast. Based on a test I ran in my oven, it is accurate when used with the Swift EGT gauge.

Jeffrey C
May 1, 2017

Perfect length to the gauge, only problem was I had ordered 2 14mm but I was sent 1 12mm and 1 14 mm. So just made a little 2mm adjustment to make it fit. otherwise I would have give it 5 stars.

July 23, 2018

I brought this as a spare ... the preivous one I brought still good but not sure if it is fromthe same manfacturer...but it was from AirSpruce at around the same price.

August 26, 2017


Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Will the Falcon EGT and CHT senders work with the Westach gauges?

We always recommend using the manufactures probes with the manufacture gauge as they have been tested to work. Others could work but you would have to install them to find out and we cannot return used probes.

Q: Is the spark plug gasket removed when using the probe?

You must keep the gasket. Place the probe in between the gasket and the spark plug.

Q: Is this a K type sensor?

No, part # 10-02287 Swift 14mm CHT sender is type "J".

Q: Is it ok to extend the wires if the gauge is farther away?

Yes, you can use the Falcon engine probe extension wire. We offer, 4,6,8 or 10 feet extension leads. 10-02339 - 4FT | 10-02341 - 6FT | 10-02344 - 8FT | 10-02346 - 10FT.

Q: These have a red and white wire. Which is high and low?

You will need to review the gauge diagram to ensure proper wiring.

View in Catalog

View Image View in Catalog