AveoAir™ Ball Vents are machined from 2024 aluminium alloy, and these lightweight vents are anodized in your choice of 2 color finishes: Silver or Black.
Installation is simple with 2-piece design, no screws are required as they simple thread together to hold securely.
ONLY AVEO VENTS come with a choice of 3 rear standard SCAT tube coupler diameters so you can optimize your air flow. Choose from 1.5", 1.75" or 2.0" diameters (38 mm, 44 mm, 50 mm).
Note: Actual finish is a matte silver, not the shiny silver in the photo.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Quality construction, easy install for a 1 1/2 scat tube. Pricey.
AVEO BALL VENT AVE-BVBLK-150
Well designed, high quality vent that belongs in an aircraft. airflow stops when closed. No extra adapters to connect to scat hose. clean & functional.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, that is for illustration purposes to show two different sizes. These vents are priced and sold individually.
Each of the Aveoair 2.00 inch ball vents weighs approximately 0.17 lbs. The 1.50 & 1.75 inch vents also weigh approximately 0.17 lbs.
FAA approval is required to replace parts on certified aircraft. You should consult with your A&P mechanic to confirm this would apply to this vent, or if it would be considered a minor alteration.
Per Aveo: The front screws onto the SCAT back so theoretically one could use a thickness of up to almost the length of the shaft of the ball vent front, but not advisable as you would want to have the SCAT back securely turned on....
Yes, they do.
There is no application chart for these vents. You will need to measure your installed vents to ensure you order the right size. Also, FAA approval is required to replace parts on certified aircraft. You should consult with your A&P mechanic to confirm this would apply to this vent, or if it would be considered a minor alteration.