This wheel fairing was originally designed to fit aircraft that are using 11x400x5 wheels and tires, but is suitable for many other aircraft using that tire size.
This wheel fairing is made from woven fiberglass and epoxy and is split vertically (lap joint) just forward of the axle center line.
Aerodynamically, this fairing is very clean.
Requires screws and nutplates to attach sections, hardware not included.
L-31 3/8" x H-10 1/4" x W- 8 1/2".
Approx weight: 1-1/2 lbs.
Note: Light fill and sanding is required for smooth ready to paint surface. A finishing service is available that will leave a primer smooth surface.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
These are made by Benchmark Composites and yes, they are USA made.