Finger strainers are for fuel tank outlets. Standard size features a brass fitting with 3/8" male pipe thread which fits AN867-3 welding flange, and 1/4" female pipe thread for valve or fuel line fitting. Screen is 16 mesh brass.
Large finger strainer has a 3/8"-NPT x 1/2"-M-NPT brass bushing with a T304 stainless steel screen. Uses welding flange AN867-4.
Very well made, arrived quickly,
Just what I was looking for. Thanks A/C Spruce
Cured my fuel tank problems on farm tractor. Cut the original plastic fitting off the tank, drilled hole slightly under 3/8, used the strainer to cut new threads in plastic. Cured my fuel flow problems 100%
Great product. Used in my dump truck saddle tank for diesel. High quality strainer for all equipment that use a pipe thread fitting. Great price!.
Haven’t installed yet, but appears to be well made. Aircraft Spruce shipped quickly at reasonable shipping expense.
Quality product and service from spruce
worked perfectly with the weld on bungs.
I place my order online and the product shipped right away. I also get emails with the tracking information, that is very helpful for me!!
Works great except the internal threads needed a little work from a pipe thread tap.
The standard finger strainer is approximately 2-11/16" long. The large finger strainer is approximately 3" long.
The thread size of the strainer is a 3/8" NPT Female and a 1/2" NPT male threads.
Standard Finger Strainer: .48" screen OD Large Finger Strainer: .60" screen OD
Yes they are both 16 mesh.
The screen is 2". The thread is 3/8 npt and it is .421" long. You would use a 3/4 wrench.
No it does not.
It is threaded 3/8 npt.