VOC compliant adhesive for seaming, splicing and bonding of gaskets, rubber matting, belts and hose to rubber, wood, metal, some plastics, glass and fabrics and to themselves.
Provides permanent, flexible bonding. Can be brushed, spread or roller coated. Will not get hard or brittle with age and resists most acids, oil, gasoline, grease, water and salt.
|Base Polymer||Nitrile Rubber|
|Base Resin||Thermosetting Phenolic|
|Total Solids %||28-32%|
|Viscosity, COS||3,000 - 10,000|
|Flash Point, ºF Seta||20|
Great stuff..works flawlessly
PLIOBOND 35 LV 1/2 PINT BRUSH TOP CAN
PLIOBOND 35 LV is a remarkable product. I find it to be the best I have ever used. Dries fast and seals strong and perfectly. I have not used any other rubber glue that can match it. I highly recommend this product for many uses because it does what the company states, to the letter! I will order again and will not use any other product. I wish it came in black though.
Unfortunately the VOC compliant adhesive is simply not the same as the regular Pliobond and is nearly useless. What was supposed to be a permanent bond turns out to be less than temporary bond. Now on to better products. Thanks, Mark
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Per Supplier: "Either product should work on this application depending on the type of rubber the sole is made of. Pliobond 35 is a little thicker than the 20. In either case,advise the user to wipe the area well with solvent on a rag, then apply to both sides and allow it to flash-off (approx. 5-10 minutes), then reapply to one side and hold together with pressure. The bond is complete when all solvent has evaporated."