Part# 05-13772
MFR Model# A-730-RD-0720


(Solid Wire End) Simple design for push-pull operation with low friction characteristics. Has .050" dia. stainless steel wire core in flexible metal casing with polyethylene liner. May be shortened as required. Max. travel 3-1/2". Available with black or red plastic knob.

Made in USA
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm -



Jeffrey M Verified Purchase


June 15, 2023

Ron E Verified Purchase


May 12, 2022

Good Quality Push Pull cable with plenty of bowden cable length to adjust the required length. Used it to activate my Matco Pneumatic Park Brake installed in my Zenith Cruzer. Aircraft Spruce shipping to Australia was well boxed and the package only took 8 days to arrive.

Greg P Verified Purchase


June 10, 2021

As advertised.

Robert L
March 30, 2020

Gary B
May 25, 2019

Gerard M
April 15, 2019

Well made, smooth glide.....Im going to have to crimp its style a bit to make it move less easy

Gaylon P
December 29, 2018

This seems to be high quality cable. I worked for my application perfectly.

Dan M
June 3, 2018

Part arrived broken so I will be returning it for a refund

Merlin P
September 14, 2019


Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What is the diameter of the knob on the A-730 Glide Free Control?

The diameter of the knob on this control is approximately 1-1/8".

Q: What is the outside diameter of the cable outer casing?

A-730 cables have a 3/16" O.D. housing.

Q: What is the hole size required to mount this A-730 glide free control in a panel?

It requires a 3/8" hole for mounting.

Q: What is the thread size of the knob on the A-730 glide free control?

The knob has 10-32 threads. Loctite is used to secure the knob from the factory when threaded on.

Q: Is the A-730 glide free control casing also stainless steel?

No, it is a galvanized housing with an inner nylon liner.

Q: What is the size of the solid wire?

A-730 controls have .050" diameter inner wire.

Q: Can I use this A-730 control for mixture or carburetor heat?

This cable does not have any specific application. It is a glide free cable with a solid wire end, so if your application calls for this style cable at this length, it should work very well. It is not an FAA approved unit.

Q: The description says, may be shortened as required. Can you please describe how that can be done? the coiled metal casing around the wire is very stiff and not easy to work.

You would first figure out the length for the inner cable and cut it to length. Then you would figure out the length of the outer coil casing(accounting for the stroke) and cut it. It may require a hacksaw or cutoff wheel to cut it.

Q: Can this cable be used inside an experimental aircraft engine compartment firewall forward? Im concerned about the heat characteristics of the cable liner.

Yes these are commonly used firewall forward on experimental aircraft.

View in Catalog

View Image View in Catalog