Cessna Jack Points - Spring Gear Type
2-15/16 in. height x 2-5/8 in. x 3-1/8 in. width with a 5/8" raised edge.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Does what it’s supposed to do!
JACK PAD CESSNA
Everyone has the product. A S always makes it easy.
The slot to place the jack is very small and makes it difficult to use the a bottle jack. Why wouldnt they just make the slot larger enough to place any kind of jack under the Jack Pad...is beyond me. What if you were to get stranded somewhere all you had access to was a bottle jack? I was able to make it work using a bottle jack but it slipped off one time and was very precarious.
JACK PAD CESSNA
Works great on my Cessna 140A!!
This jack point would no stay on the gear leg during raising without using secondary device to hold in place. I used a block of wood on the other side of the gear leg and a “C” clamp to secure jack point to gear leg. Bad design by itself and should not be trusted without addition positive securement.
Does not fit either my 150 or 172 due to my foot step being in the way. Probably would have worked fine except for that. I notice the taper of the pad doesnt perfectly align with either of my landing gear, but it would still work, if I didnt have a foot rest. Just sits on the shelf, unused.
This product DOES NOT FIT 172 LEGS !!! It fits right where the foot step is... big mistake buying this to fit 172. I saw another owner made same comment and thought it was just his plane ... but he was right and it doesn’t fit any of my 3 Cessna 172 legs
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
These dimensions are listed as the inside dimensions.
Yes, it should fit with both the 140 and the 172.
If that has a flat spring style landing gear then it would work.
It looks like it may be an issue if the step is installed on the gear leg. You could use the dims to measure your leg and determine if that could be an issue. If it is, something like 12-00837 may be a better option as it is adjustable.