|Required for installation of Fuel Flow Elbow.|
fit great on an old generator and no parts were available from the manufacture .
Excellent product and price.
Installed this through a 1/2 hole instead of recommended 33/64 hole, simply because I did not have a 33/64 drill bit. I was still able to insert this fitting into a plastic tank, using a small amount of Fuel Lube lubricant, and a small screwdriver to push the edges of the bushing into place. Have not flown the aircraft or pressure tested this bushing, but it seems to be very snug and resistant to movement after the fuel flow elbow was inserted. I highly recommend using the Fuel Lube to install this rubber bushing, helps create a seal and lubricates the parts during the assembly process.
The bushing requires a 1/2" hole.
Yes, these specs are correct.