SAME DAY SHIPPING ON ORDERS PLACED BY 4 PM | 877-4-SPRUCE

Falcon Vacuum Directional Gyro

$797.00/Each
Quantity
Add to Wishlist
Part# 10-22950
MFR Model# DG02V-3

Overview

The vertical rotating azimuth card is controlled by a precision gyroscope air-driven. The directional gyro will give correct heading information through ±60° of aircraft attitude in roll and pitch, 360° in yaw. A caging knob is provided to reset the gyro to the magnetic compass. Similar to Air Italia Gyros. Non-TSO’d - for Experimental Aircraft Only

Model: DG02V-3
Dimensions: 3-3/8" x 5-5/16"/134.95mm
Weight: 2.25lb/984g.



Made in China
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

  • Frequently Purchased With
  • Customers Also Viewed
  • Related Items

Reviews

Installation pretty straightforward ,but had to modify hole in panel for adjusting knob , shaft is larger in diameter than old one and closer to face of instrument , but with a small file was easily done , then bolted right in . Works great , huge improvement over old one. 4 stars.

Reg E Verified Purchase

Falcon 3-1/8 Vac Dg DG02V-3

September 29, 2025

Reg E Verified Purchase

Falcon 3-1/8 Vac Dg DG02V-3

September 29, 2025

Q&A

Please note, Aircraft Spruce ®'s personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce ® assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Will this Falcon directional gyro fit a 1970 Cessna 150K?

This gauge in not certified (TSO'd) and is for use in experimental aircraft only.

Q: Will this Falcon gyro fit in a 3 1/8" inch cutout?

Yes it is a 3-1/8" gauge.

Q: Will this Falcon gyro fit in a 3 1/8" inch cutout?

Yes it is a 3-1/8" gauge.

View in Catalog

View Image View in Catalog