Stainless Steel Hand Squeezer

Add to Wishlist
Part# 12-01464
MFR Model# 16301


This stainless steel hand squeeze made of quality stainless steel construction. Features include an adjustable set holder (accepts all sets and dies with 3/16" shank) and a locking lever arm. Yokes are easily interchangeable by simply removing three roll pins and designed to accept yokes and parts made by other stainless steel hand squeeze manufacturers. Includes a 3" Yoke. 1.5" is sold separately
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm -

  • Accessories
  • Frequently Purchased With
  • Customers Also Viewed


Good but wanted a little stronger.

Craig W Verified Purchase


June 20, 2023

Michael J Verified Purchase


June 2, 2021

High quality and best design ever! Thanks to ATS for the care and effort put into this tool. Worth the extra change to enjoy using this quality tool.

Aircraft R
February 14, 2021

all good

April 12, 2020

all good

April 2, 2020

I bought the 3 model and various lengths of the economy Rivet Sets and it easily squeezed soft rivets without distorting. I havent done any hardened rivets yet but Im confident it will work great.

September 20, 2017

I returned a cheaper hand rivet squeezer that flexed to the point that I could not get a square squeeze. I returned it for this squeezer, and it worked great.

Bill G
March 22, 2017

I bought the hand squeezer because I had friends that had bought the same unit. My old squeezer had worn out and I needed to replace it. It functioned just fine as a squeezer however, I had to disassemble it and cleaned the threads on the mandrel adjustment. It had not been tested prior to shipping and to adjust it you needed to always insert a pin to turn the mandrel. That shouldnt be the case. Feedback should be sent to the manufacture to clean those threads up prior to assembly and shipping

Rory B Verified Purchase


November 30, 2021


Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: I understand it comes with the 3 throat. How wide is the throat or in other words how long is the rivet that can be squeezed? Also, does it come with the dies , or they have to be bought separately? Thank you

The gap is 1-1/4, and it does not come with dies.

Q: Can this tool squeeze 5/32 470 hard aluminum rivets? Can I use 2 cupped dies to get a round head on both ends of the installed rivet or do I have to use a flush die on one side and a cupped die in the other?

Yes, This will squeeze a 5/32 hard rivet. For Aircraft applications a cupped and flat die is prefered, the tool is capable of performing both sets of dies.

View in Catalog

View Image View in Catalog