|Tube Dia.||Dash No.
Loop-type cushioned aluminum alloy clamp. Cushion (non-fuel resistant) is bonded to inner surface and edges of clamp. WDG clamps are cushion wedge type. Cushion assures tight fit and eliminates vibration, thus preventing line abrasion.
Note: Revision E only applies to WDG clamps. See Tech Data Sheet.
Shipped the correct item at great shipping time.
I need it for holding the trim seal, coex 10 feets, and I could used 6 of them, need to know the price on those 6 on the low lowed price please thank you. 754-422-0101
excellent produt and a great price
They will work fine. I had a senior moment and miss ordered earlier. OOPS. When I quit flying, I will give the excess to someone.
All of the below items were trying to a place that I was unsure about. So I ordered more than I needed and through trial and error I would select what I needed. Then give the excess to someone.
on time great!
They will work fine for me to install a regulator for a Jasco alternator. I needed to remove the rudder for them to match up with the motor mount.
WDG clamps are cushion wedge type clamps. You can see this wedge clearly by looking at the third image (far right) on this web page.
The diameter tolerance of the mounting holes is .199 through .209 which would require a #10 screw or AN3 bolt. All clamps listed on this web page have the same size mounting holes.